OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

do

Executes most commands from all CONFIGURATION modes without returning to EXEC mode.

Syntax
do command
Parameters
command — Enter an EXEC-level command.
Default
Not configured
Command Mode
INTERFACE
Usage Information
None
Example
OS10(config)# interface ethernet 1/1/7
                                       OS10(conf-if-eth1/1/7)# no shutdown
                                       OS10(conf-if-eth1/1/7)# do show running-configuration
                                       ...
                                       !
                                       interface ethernet1/1/7
                                       no shutdown
                                       !
                                       ...
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\