OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

dot1x host-mode

Allows 802.1X authentication for either a single supplicant or multiple supplicants on an interface.

Syntax
dot1x host-mode {multi-host | multi-auth}
Parameters
  • multi-host — Allows attachment of multiple hosts to a single 802.1X-enabled port. You can only authorize one of the attached clients for all clients to grant network access. If the port becomes unauthorized (re-authentication fails or receives an EAPOL-logoff message), the device denies network access to all of the attached clients.
  • multi-auth — Allows 802.1X authentication for each connected host.
Default
Multi-host
Command Mode
INTERFACE
Usage Information
The no version of this command resets the value to the default.
Example
OS10(conf-range-eth1/1/7-1/1/8)# dot1x host-mode multi-auth
                                       
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\