OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

dot1x timeout quiet-period

Sets the number of seconds that the device remains in quiet state following a failed authentication exchange with a supplicant.

Syntax
dot1x timeout quiet-period seconds
Parameters
quiet period seconds — Enter the number of seconds for the 802.1X quiet period timeout (1 to 65535).
Default
60 seconds
Command Mode
INTERFACE
Usage Information
The no version of this command resets the value to the default.
Example
OS10(conf-range-eth1/1/7-1/1/8)# dot1x timeout quiet-period 120
                                       
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\