OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

dot1x timeout supp-timeout

Sets the number of seconds that the device waits for the supplicant to respond to an EAP request frame before the device retransmits the frame.

Syntax
dot1x timeout supp-timeout seconds
Parameters
supp-timeout seconds — Enter the number of seconds for the 802.1X supplicant timeout (1 to 65535).
Default
30 seconds
Command Mode
INTERFACE
Usage Information
The no version of this command resets the value to the default.
Example
OS10(conf-range-eth1/1/7-1/1/8)# dot1x timeout supp-timeout 45
                                       
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\