OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

duplex

Configures duplex mode on the Management port.

Syntax
duplex {full | half | auto}
Parameters
  • full — Specify to set the physical interface to transmit in both directions.
  • half — Specify to set the physical interface to transmit in only one direction.
  • auto — Specify to set the physical interface to transmit automatically.
Defaults
Not configured
Command Mode
CONFIGURATION
Usage Information
This command can only be used on the Management port. The no version of this command resets the value to the default.
Example
OS10(conf-if-ma-1/1/1)# duplex auto
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\