OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

ebgp-multihop

Allows EBGP neighbors on indirectly connected networks.

Syntax
ebgp-multihop hop count
Parameters
hop count — Enter a value for the number of hops, from 1 to 255.
Default
1
Command Mode
ROUTER-NEIGHBOR
Usage Information
This command avoids installation of default multihop peer routes to prevent loops and creates neighbor relationships between peers. Networks indirectly connected are not valid for best path selection. The no version of this command removes multihop session.
Example
OS10(conf-router-neighbor)# ebgp-multihop 2
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\