OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

eee

Enables or disables energy-efficient Ethernet (EEE) on physical ports.

Syntax
eee
Parameters
None
Default
Enabled on Base-T devices and disabled on S3048-ON and S4048T-ON.
Command Mode
Interface
Usage Information
To disable EEE, use the no version of this command.
Example (Enable EEE)
OS10(config)# interface ethernet 1/1/1
                                       OS10(conf-if-eth1/1/1)# eee
                                    
Example (Disable EEE)
OS10(config)# interface ethernet 1/1/2
                                       OS10(conf-if-eth1/1/2)# no eee
                                    
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\