OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

Enable 802.1X

  1. Enable 802.1X globally in CONFIGURATION mode.
    dot1x system-auth-control
  2. Enter an interface or a range of interfaces in INTERFACE mode.
    interface 
                                           range
                                        
  3. Enable 802.1X on the supplicant interface only in INTERFACE mode.
    dot1x port-control auto

Configure and verify 802.1X configuration

OS10(config)# dot1x system-auth-control
                                 OS10(config)# interface range 1/1/7-1/1/8
                                 OS10(conf-range-eth1/1/7-1/1/8)# dot1x port-control auto
                                 OS10(conf-range-eth1/1/7-1/1/8)# dot1x re-authentication
                                 OS10(conf-range-eth1/1/7-1/1/8)# do show dot1x interface ethernet 1/1/7
                                 
                                 802.1x information on ethernet1/1/7
                                 -------------------------------------
                                 Dot1x Status:             Enable
                                 Port Control:             AUTO
                                 Port Auth Status:         UNAUTHORIZED
                                 Re-Authentication:        Enable
                                 Tx Period:                60 seconds
                                 Quiet Period:             60 seconds
                                 Supplicant Timeout:       30 seconds
                                 Server Timeout:           30 seconds
                                 Re-Auth Interval:         3600 seconds
                                 Max-EAP-Req:              2
                                 Host Mode:                MULTI_HOST
                                 Auth PAE State:           Initialize
                                 Backend State:            Idle
                              

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\