OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

Enable multipath

You can have one path to a destination by default, and enable multipath to allow up to 64 parallel paths to a destination. The show ip bgp network command includes multipath information for that network.

  • Enable multiple parallel paths in ROUTER-BGP mode.
    maximum-paths {ebgp | ibgp} 
                                           number
                                        

Enable multipath

OS10(config)# router bgp 10
                                 OS10(conf-router-bgp-10)# maximum-paths ebgp 10
                              

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\