OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

Enable OSPFv3

  1. Enable OSPFv3 globally and configure an OSPFv3 instance in CONFIGURATION mode.
    router ospfv3 
                                        instance-number
                                     
  2. Enter the interface information to configure the interface for OSPFv3 in INTERFACE mode.
    interface ethernet 
                                        node/slot/port[:subport]
                                     
  3. Enable (or bring up) the interface in INTERFACE mode.
    no shutdown
  4. Disable the default switchport configuration and remove it from an interface or a LAG port in INTERFACE mode.
    no switchport
  5. Enable the OSPFv3 on an interface in INTERFACE mode.
    ipv6 ospfv3 
                                        process-id area 
                                        area-id
                                     
    • process-id — Enter the OSPFv3 process ID for a specific OSPFv3 process (1 to 65535).
    • area-id — Enter the OSPF area ID as an IP address (A.B.C.D) or number (1 to 65535).
Enable OSPFv3
OS10(config)# router ospfv3 100
                                 OS10(config-router-ospfv3-100)# exit
                                 OS10(config)#  interface ethernet 1/1/1
                                 OS10(conf-if-eth1/1/1)# no shutdown
                                 OS10(conf-if-eth1/1/1)# no switchport
                                 OS10(conf-if-eth1/1/1)# ipv6 ospfv3 300 area 0.0.0.0
                              

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\