OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

enforce-first-as

Enforces the first AS in the AS path of the route received from an external border gateway protocol (EBGP) peer to be the same as the configured remote AS.

Syntax
enforce-first-as
Parameters
None
Default
Enabled
Command Mode
ROUTER-BGP
Usage Information
To verify statistics of routes rejected, use the show ip bgp neighbors command. If routes are rejected, the session is reset. In the event of a failure, the existing BGP sessions flap. For updates received from EBGP peers, BGP ensures that the first AS of the first AS segment is always the AS of the peer, otherwise the update drops and the counter increments. The no version of this command turns off the default.
Example
OS10(conf-router-bgp-1)# enforce-first-as
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\