OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

ets mode on

Enables ETS on an interface.

Syntax
ets mode on
Parameter
None
Default
Disabled
Command Mode
INTERFACE
Usage Information
Enable ETS on all switch interfaces in SYSTEM-QOS mode or on an interface or interface range in INTERFACE mode. The no version of this command disables ETS.
Example
OS10(config-sys-qos)# ets mode on 
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\