OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

fall-over

Enables or disables BGP session fast fall-over for BGP neighbors.

Syntax
fall-over
Parameters
None
Default
Disabled
Command Mode
ROUTER-NEIGHBOR
Usage Information
Configure the BGP fast fall-over on a per-neighbor or peer-group basis. When you enable this command on a template, it simultaneously enables on all peers that inherit the peer group template. When you enable fall-over, BGP tracks IP reachability to the peer remote address and the peer local address. Whenever either address becomes unreachable — no active route exists in the routing table for peer IPv6 destinations or local address — BGP brings down the session with the peer. The no version of this command disables fall-over.
Example
OS10(conf-router-neighbor)# fall-over 
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\