OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

fast-converge

Sets the minimum LSA origination and arrival times to zero (0) allowing more rapid route computation so that convergence takes less time.

Syntax
fast-converge convergence-level
Parameters
convergence-level — Enter a desired convergence level value (1 to 4).
Default
Not configured
Command Mode
ROUTER-OSPF
Usage Information
Convergence level 1 (optimal) meets most convergence requirements. Only select higher convergence levels following consultation with Dell Technical Support. The no version of this command disables the fast-convergence configuration.
Example
OS10(conf-router-ospf-10)# fast-converge 3
                                       
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\