OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

fast-external-fallover

Resets BGP sessions immediately when a link to a directly connected external peer fails.

Syntax
fast-external-fallover
Parameters
None
Default
Not configured
Command Mode
ROUTER-BGP
Usage Information
Fast external fall-over terminates the EBGP session immediately after the IP unreachability or link failure is detected. This only applies after you manually reset all existing BGP sessions. For the configuration to take effect, use the clear ip bgp command. The no version of this command disables fast external fallover.
Example
OS10(conf-router-bgp-10)# fast-external-fallover
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\