OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

fc zoneset

Creates an FC zoneset and adds the existing FC zones to the zoneset.

Syntax
fc zoneset zoneset-name
Parameters
zoneset-name — Enter a name for the FC zoneset. The name must start with a letter and may contain characters: A-Z, a-z, 0-9, $, _, -, ^
Defaults
Not configured
Command Mode
CONFIGURATION
Usage Information

The no version of this command removes the FC zoneset.

Example
OS10(config)# fc zoneset set
                                       OS10(conf-fc-zoneset-set)# member hba1
                                    
Supported Releases
10.3.1E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\