OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

fcoe

Adds FCoE parameters to vfabric.

Syntax
fcoe {fcmap fc-map | fcf-priority fcf-priority-value | fka-adv-period adv-period | vlan-priority vlan-priority-value | keep-alive}
Parameters
— Enter the FC map ID, ranging from 0xefc00-0xefcff.
  • fc-map — Enter the FC map ID, ranging from 0xefc00-0xefcff.
  • fcf-priority-value — Enter the FCF priority value, ranging from 1 to 255.
  • adv-period — Enter the FCF keepalive advertisement period ranging from 8 to 90 seconds.
  • vlan-priority-value — Enter the VLAN priority value, ranging from 0 to 7.
Defaults
  • fcmap—0x0EFC00
  • fcf-priority—128
  • fka-adv-period—8
  • vlan-priority—3
  • keep-alive—True
Command Mode
Vfabric CONFIGURATION
Usage Information

The no version of this command disables the FCoE parameters.

Example
OS10(config)# vfabric 10
                                       OS10(conf-vfabric-10)# name 10
                                       OS10(conf-vfabric-10)# fcoe fcmap 0x0efc01
                                       OS10(conf-vfabric-10)# fcoe fcf-priority 128
                                       OS10(conf-vfabric-10)# fcoe fka-adv-period 8
                                       OS10(conf-vfabric-10)# fcoe vlan-priority 3
                                       
                                    
Supported Releases
10.3.1E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\