OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

fip-snooping fc-map

Configure the FC map value for specific VLAN.

Syntax
fip-snooping fc-map fc-map
Parameters
fc-map — Enter the FC map ID, ranging from 0xefc00 to 0xefcff.
Defaults
Not configured
Command Mode
VLAN INTERFACE
Usage Information

The no version of this command disables the FC map configuration.

Example
OS10(config)# interface vlan 3
                                       OS10(conf-if-vl-3)# fip-snooping fc-map 0xEFC64
                                    
Supported Releases
10.4.0E(R1) or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\