OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

fip-snooping port-mode fcf 

Sets the FIP snooping port mode to FCF for interfaces.

Syntax
fip-snooping port-mode fcf
Parameters
None
Defaults
ENode port mode
Command Mode
INTERFACE
Usage Information

By default, the port mode of an interface is set to ENode. Use this command to change the port mode to FCF. You can set the port mode to FCF only after enabling the FIP snooping feature.

The no version of this command resets the port mode to ENode.

Example
OS10(config)# interface ethernet 1/1/32
                                       OS10(conf-if-eth1/1/32)# fip-snooping port-mode fcf
                                       
                                    
Supported Releases
10.4.0E(R1) or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\