OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

flowcontrol

Enables or disables link-level flow control on an interface.

Syntax
flowcontrol [receive | transmit] [on | off]
Parameters
  • receive — (Optional) Indicates the port can receive flow control packets from a remote device.
  • transmit — (Optional) Indicates the local port can send flow control packets to a remote device.
  • on — (Optional) When used with receive, allows the local port to receive flow control traffic. When used with transmit, allows the local port to send flow control traffic to the remote device.
  • off — (Optional) When used with receive, disables the remote device from sending flow control traffic to the local port. When used with transmit, disables the local port from sending flow control traffic to the remote device.
Default
Disabled ( off)
Command Mode
INTERFACE
Usage Information
The no version of this command returns the value to the default.
Example
OS10(conf-if-eth1/1/2)# flowcontrol transmit on
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\