OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

F_Port on Ethernet

OS10 supports configuring F_Port mode on an Ethernet port that is connected to converged network adapters (CNA).

After enabling F_Port mode, configure a vfabric and apply the vfabric to Ethernet ports connected to CNA.

You can configure only one vfabric in F_Port mode.

You can apply the configured vfabric to multiple Ethernet interfaces. You can also add the Ethernet interfaces to a port-channel and apply the vfabric to the port-channel.

Example configuration
OS10(config)# feature fc domain-id 100
                                 OS10(config)# vfabric 100
                                 OS10(conf-vfabric-100)# name 100
                                 OS10(conf-vfabric-100)# vlan 1023
                                 OS10(conf-vfabric-100)# fcoe fcmap 0xEFC64
                                 OS10(conf-vfabric-100)# zoneset activate set
                                 OS10(conf-vfabric-100)# zone default-zone permit
                                 OS10(conf-vfabric-100)# exit
                                 OS10(config)# interface ethernet 1/1/30 
                                 OS10(conf-if-eth1/1/30)# vfabric 100
                              

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\