OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

Group version

Configure a VRRP version for the system. Define either VRRPv2 — vrrp version 2, VRRPv3 — vrrp version 3, or vrrp version both to migrate a system from VRRPv2 to VRRPv3.

  • Configure the VRRP version for IPv4 in INTERFACE mode.
    vrrp version

Configure VRRP version 3

OS10(config)# vrrp version 3

Use the vrrp version both command in Configuration mode to migrate from VRRPv2 to VRRPv3. When you set the VRRP version to vrrp version both, the switch sends and receives both VRRPv2 or VRRPv3 packets.

  1. Set the switch with the lowest priority to vrrp version both.
  2. Set the switch with the highest priority to vrrp version 3.
  3. Set all switches from vrrp version both to vrrp version 3.

Migrate IPv4 group from VRRPv2 to VRRPv3

OS10_backup_switch1(config)# vrrp version both
                                 OS10_backup_switch2(config)# vrrp version both
                              

Set master switch to VRRPv3

OS10_master_switch(config)# vrrp version 3

Set backup switches to VRRPv3

OS10_backup_switch1(config)# vrrp version 3
                                 OS10_backup_switch2(config)# vrrp version 3
                              

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\