OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

interface line-protocol

Configures an object to track a specific interface's line-protocol status.

Syntax
interface interface line-protocol
Parameters
interface — Enter the interface information:
  • ethernet — Physical interface.
  • port-channel — Enter the port-channel identifier.
  • vlan — Enter the VLAN identifier.
  • loopback — Enter the Loopback interface identifier.
  • mgmt — Enter the Management interface.
Defaults
Not configured
Command Mode
CONFIGURATION
Usage Information
None
Example
OS10(conf-track-100)# interface ethernet line-protocol
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\