OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

interface loopback

Configures a loopback interface.

Syntax
interface loopback id
Parameters
id — Enter the loopback interface ID number (0 to 16383).
Default
Not configured
Command Mode
CONFIGURATION
Usage Information
The no version of this command deletes the loopback interface.
Example
OS10(config)# interface loopback 100
                                       OS10(conf-if-lo-100)#
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\