OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

Interfaces

You can configure and monitor physical interfaces (Ethernet), port-channels, and VLANs in L2 or L3 modes.

Table 1. Interface types . Interface types
Interface type Supported / default mode Requires creation / default status
Ethernet (PHY) L2, L3 / unset No / no shutdown (enabled)
Management N/A No / no shutdown (enabled)
Loopback L3 / L3 Yes / no shutdown (enabled)
Port-channel L2, L3 / unset Yes / shutdown (disabled)
VLAN L2, L3 / L3 Yes (except default) / shutdown (disabled)

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\