OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

Interfaces

Create a LAG and then add LAG member interfaces. By default, all interfaces are in no shutdown and switchport modes.

  1. Create a LAG in CONFIGURATION mode.
    interface port-channel 
                                           port-channel number
                                        
  2. Enter INTERFACE mode.
    interface ethernet 
                                           node/slot/port[:subport]
                                        
  3. Set the channel group mode to Active in INTERFACE mode.
    channel-group 
                                           number mode active
                                        

Configure dynamic LAG interfaces

OS10(config)# interface port-channel 10
                                 OS10(conf-if-po-10)# exit
                                 OS10(config)# interface ethernet 1/1/10
                                 OS10(conf-if-eth1/1/10)# no switchport
                                 OS10(conf-if-eth1/1/10)# channel-group 10 mode active
                                 OS10(conf-if-eth1/1/10)# exit
                                 OS10(config)# interface ethernet 1/1/11
                                 OS10(conf-if-eth1/1/11)# no switchport
                                 OS10(conf-if-eth1/1/11)# channel-group 10 mode active
                              

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\