OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

ip access-class

Filters connections based on an IPv4 access list in virtual terminal line.

Syntax
ip access-class access-list-name
Parameters
access-list-name —Enter the access list name.
Default
Not configured
Command Mode
LINE VTY CONFIGURATION
Usage Information
The no version of this command removes the filter.
Example
OS10(config)# line vty
                                       OS10(config-line-vty)# ip access-class deny10
                                       
                                    
Supported Releases
10.4.0E(R1) or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\