OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

ip access-list

Creates an IP access list to filter based on an IP address.

Syntax
ip access-list access-list-name
Parameters
access-list-name — Enter the name of an IPv4 access list. A maximum of 140 characters.
Default
Not configured
Command Mode
CONFIGURATION
Usage Information
None
Example
OS10(config)# ip access-list acl1
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\