OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

ip address

Configures IP address to an interface.

Syntax
ip address ip–address/mask
Parameters
ip–address/mask — Enter the IP address.
Defaults
None
Command Mode
INTERFACE
Usage Information
The no version of this command removes the IP address set for the interface.
Example
OS10(config)# interface ethernet 1/1/1
                                       OS10(conf-if-eth1/1/1)# ip address 10.1.1.0/24
                                       
                                    
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\