OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

ip host

Configures mapping between the host name server and the IP address.

Syntax
ip host [ host-name] address
Parameters
  • host-name — (Optional) Enter the name of the host.
  • address — Enter an IPv4 or IPv6 address of the name server in A.B.C.D or A::B format.
Default
Not configured
Command Mode
CONFIGURATION
Usage Information
The name-to-IP address table uses this mapping information to resolve host names. The no version of this command disables the mapping.
Example
OS10(config)# ip host dell 1.1.1.1
                                       
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\