OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

ip name-server

Configures up to a three IPv4 or IPv6 addresses used for network name servers.

Syntax
ip name-server ip–address [ ip-address2 ip-address3]
Parameters
  • ip–address — Enter the IPv4 or IPv6 address of a domain name server to use for completing unqualified names (incomplete domain names that cannot be resolved).
  • ip–address2 ip-address3 — (Optional) Enter up two additional IPv4 or IPv6 name servers, separated with a space.
Default
Not configured
Command Mode
CONFIGURATION
Usage Information
OS10 does not support sending DNS queries over a VLAN. DNS queries are sent out on all other interfaces, including the Management port. You can separately configure both IPv4 and IPv6 domain name servers. In a dual stack setup, the system sends both A (request for IPv4) and AAAA (request for IPv6) record requests to a DNS server even if you only configure this command. The no version of this command removes the IP name-server configuration.
Example
OS10(config)# ip name-server 10.1.1.5 
                                       
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\