OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

ip ospf authentication-key

Configures a text authentication key to enable OSPF traffic on an interface.

Syntax
ip ospf authentication-key key
Parameters
key — Enter an eight-character string for the authentication key.
Defaults
Not configured
Command Mode
INTERFACE
Usage Information
To exchange OSPF information, all neighboring routers in the same network must use the same authentication key. The no version of this command deletes the authentication key.
Example
OS10(config)# interface ethernet 1/1/1
                                       OS10(conf-if-eth1/1/1)# ip ospf authentication-key sample
                                       
                                    
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\