OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

ip ospf cost

Changes the cost associated with the OSPF traffic on an interface.

Syntax
ip ospf cost cost
Parameters
cost — Enter a value as the OSPF cost for the interface (1 to 65335).
Default
Based on bandwidth reference
Command Mode
INTERFACE
Usage Information
Interface cost is based on the auto-cost command if not configured. This command configures OSPF over multiple vendors to ensure that all routers use the same cost. If you manually configure the cost, the calculated cost based on the reference bandwidth does not apply to the interface. The no version of this command removes the IP OSPF cost configuration.
Example
OS10(config)# interface vlan 10
                                       OS10(conf-if-vl-1)# ip ospf cost 10
                                       
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\