OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

ip ospf network

Sets the network type for the interface.

Syntax
ip ospf network {point-to-point | broadcast}
Parameters
  • point-to-point — Sets the interface as part of a point-to-point network.
  • broadcast — Sets the interface as part of a broadcast network.
Default
Broadcast
Command Mode
INTERFACE
Usage Information
The no version of this command resets the value to the default.
Example
OS10(conf-if-eth1/1/1)# ip ospf network broadcast
                                       
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\