OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

ip ospf retransmit-interval

Sets the retransmission time between lost LSAs for adjacencies belonging to the interface.

Syntax
ip ospf retransmit-interval seconds
Parameters
seconds — Enter a value in seconds as the interval between retransmission (1 to 3600).
Default
5 seconds
Command Mode
INTERFACE
Usage Information
Set the time interval to a number large enough to avoid unnecessary retransmission. The no version of this command resets the value to the default.
Example
OS10(conf-if-eth1/1/6)# ip ospf retransmit-interval 20
                                       
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\