OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

ip ospf transmit-delay

Sets the estimated time required to send a link state update packet on the interface.

Syntax
ip ospf transmit-delay seconds
Parameters
seconds — Set the time (in seconds) required to send a link-state update (1 to 3600).
Default
1 second
Command Mode
INTERFACE
Usage Information
Set the estimated time required to send a link-state update packet. When you set the ip ospf transmit-delay value, take into account the transmission and propagation delays for the interface. The no version of this command resets the value to the default.
Example
OS10(conf-if-eth1/1/4)# ip ospf transmit-delay 5
                                       
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\