OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

ip prefix-list permit

Creates a prefix-list to permit route filtering from a specified network address.

Syntax
ip prefix-list name permit [A.B.C.D/x [ge | le]] prefix-len
Parameters
  • name — Enter the name of the prefix list.
  • A.B.C.D/x — (Optional) Enter the source network address and mask in /prefix format (/x).
  • ge — Enter to indicate the network address is greater than or equal to the range specified.
  • le — Enter to indicate the network address is less than or equal to the range specified.
  • prefix-len — Enter the prefix length.
Defaults
Not configured
Command Mode
CONFIGURATION
Usage Information
The no version of this command removes the specified prefix-list.
Example
OS10(config)# ip prefix-list allowprefix permit 10.10.10.1/16 ge 10
Supported Release
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\