OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

ip prefix-list seq permit

Configures a filter to permit route filtering from a specified prefix list.

Syntax
ipv6 prefix-list [name] seq num permit A::B/x [ge | le} prefix-len
Parameters
  • name — Enter the name of the prefix list.
  • num — Enter the sequence list number.
  • A.B.C.D/x — Enter the source network address and mask in /prefix format (/x).
  • ge — Enter to indicate the network address is greater than or equal to the range specified.
  • le — Enter to indicate the network address is less than or equal to the range specified.
  • prefix-len — Enter the prefix length.
Defaults
Not configured
Command Mode
CONFIGURATION
Usage Information
The no version of this command removes the specified prefix list.
Example
OS10(config)# ip prefix-list seqprefix seq 65535 permit 10.10.10.1/16 le 30
Supported Release
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\