OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

ip telnet server vrf

Configures the Telnet server for the management VRF instance.

Syntax
ip telnet server vrf management
Parameters
  • management — Configures the management VRF to be used to reach the Telnet server.
Default
The Telnet server is reachable on the default VRF.
Command Mode
CONFIGURATION
Usage Information
By default, the Telnet server is disabled. To enable the Telnet server, enter the telnet enable command. To configure the Telnet server to be reachable on the management VRF instance, use the ip telnet server vrf management command.
Example
OS10(config)# ip telnet server vrf management
Supported Releases
10.4.0E(R1) or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\