OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

ipv6 address autoconfig

Acquires global IPv6 addresses by using the network prefix obtained from router advertisements.

Syntax
ipv6 address autoconfig
Parameters
None
Defaults
Disabled except on the management interface
Command Mode
INTERFACE
Usage Information
  • This command sets an interface in Host mode to perform IPv6 stateless auto-configuration by discovering prefixes on local links, and adding an EUI-64 based interface identifier to generate each IPv6 address. The command disables IPv6 forwarding. Addresses are configured depending on the prefixes received in router advertisement messages.
  • The no version of this command disables IPv6 address autoconfiguration, resets the interface in Router mode, and re-enables IPv6 forwarding.
Example
OS10(config)# interface ethernet 1/1/1
                                       OS10(conf-if-eth1/1/1)# no switchport
                                       OS10(conf-if-eth1/1/1)# ipv6 address autoconfig
                                       OS10(conf-if-eth1/1/1)#
                                       
                                    
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\