OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

ipv6 address eui-64

Configures a global IPv6 address on an interface by entering only the network prefix and length.

Syntax
ipv6 address ipv6-prefix/prefix-length eui-64
Parameters
ipv6-prefix — Enter an IPv6 prefix in x:x::y/mask format.
Defaults
None
Command Mode
INTERFACE
Usage Information
Use this command to manually configure an IPv6 address in addition to the link-local address generated with stateless autoconfiguration. Specify only the network prefix and length. The 64-bit interface ID is automatically computed from the MAC address. This command enables IPv6 processing on the interface. The no version of this command removes the IPv6 address configuration.
Example
OS10(config)# interface mgmt 1/1/1
                                       OS10(conf-if-ma-1/1/1)# ipv6 address 2111:dddd:0eee::/64 eui-64
                                    
Supported Releases
10.4.0E(R1) or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\