OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

ipv6 address link-local

Configures a link-local IPv6 address on the interface to use instead of the link-local address that is automatically configured with stateless autoconfiguration.

Syntax
ipv6 address ipv6-prefix link-local
Parameters
ipv6-prefix — Enter an IPv6 prefix in x:x::y/mask format.
Defaults
None
Command Mode
INTERFACE
Usage Information
  • An interface can have only one link-local address. By default, an IPv6 link-local address is automatically generated with a MAC-based EUI-64 interface ID when a router boots up and IPv6 is enabled. Use this command to manually configure a link-local address to replace the autoconfigured address. For example, to configure a more user-friendly link-local address, replace fe80::eef4:bbff:fefb:fa30/64 with fe80::1/64.
  • The no version of this command removes the specified link-local address.
Example
OS10(config)# interface mgmt 1/1/1
                                       OS10(conf-if-ma-1/1/1)# ipv6 address 2111:dddd:0eee::22/64 link-local
                                    
Supported Releases
10.4.0E(R1) or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\