OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

IPv6 destination unreachable

By default, when no matching entry for an IPv6 route is found in the IPv6 routing table, a packet is dropped and no error message is sent. You can enable the capability to send an IPv6 destination unreachable error message to the source without dropping the packet.

Enable IPv6 unreachable destination messaging

OS10(config)# interface ethernet 1/1/8
                              OS10(conf-if-eth1/1/8)# ipv6 unreachables
                           

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\