OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

ipv6 enable

Enables and disables IPv6 forwarding on an interface configured with an IPv6 address.

Syntax
ipv6 enable
Parameters
None
Defaults
None
Command Mode
INTERFACE
Usage Information
  • The no version of this command disables IPv6 forwarding.
  • Use this command to disable and re-enable IPv6 forwarding on an interface for security purposes or to recover from a duplicate address discovery (DAD) failure.
Example
OS10(config)# interface ethernet 1/1/1
                                       OS10(conf-if-eth1/1/1)# ipv6 address 2111:dddd:0eee::22/128
                                       OS10(conf-if-eth1/1/1)# no ipv6 enable
                                       OS10(conf-if-eth1/1/1)# ipv6 enable
                                    
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\