OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

IPv6 hop-by-hop options

A hop-by-hop header extension in an IPv6 packet contains options that are processed by all IPv6 routers in the packet's path. By default, hop-by-hop header options in an IPv6 packet are not processed locally. To enable local processing of IPv6 hop-by-hop options on an interface, use the ipv6 hop-by-hop command.

Enable IPv6 hop-by-hop options forwarding

OS10(config)# interface ethernet 1/1/8
                              OS10(conf-if-eth1/1/8)# ipv6 hop-by-hop
                           

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\