OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

ipv6 hop-by-hop

Enables and disables processing hop-by-hop options in IPv6 packet headers.

Syntax
ipv6 hop-by-hop
Parameters
None
Defaults
Hop-by-hop header options in an IPv6 packet are not processed on an interface.
Command Mode
INTERFACE
Usage Information
  • Use this command to enable local processing of IPv6 packets with hop-by-hop options in conformance with RFC 8200, IPv6 Specification.
  • The no version of this command disables IPv6 processing of hop-by-hop header options.
Example: Disable hop-by-hop option processing
OS10(config)# interface ethernet 1/2/3
                                       OS10(conf-if-eth1/2/3)# no ipv6 hop-by-hop
                                    
Supported Releases
10.4.0E(R1) or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\