OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

ipv6 nd hop-limit

Sets the hop limit advertised in RA messages and included in IPv6 data packets sent by the router.

Syntax
ipv6 nd hop-limit hops
Parameters
  • hop-limit hops — Enter the maximum number of hops allowed for RA messages (0 to 255).
Defaults
64 hops
Command Mode
INTERFACE
Usage Information
The configured hop limit is advertised in RA messages and included in IPv6 data packets sent by the router. 0 indicates that no hop limit is specified by the router.
Example
OS10(config)# interface ethernet 1/2/3
                                       OS10(conf-if-eth1/2/3)# ipv6 nd hop-limit 100
                                    
Supported Releases
10.4.0E(R1) or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\