OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

ipv6 nd mtu

Sets the maximum transmission unit (MTU) used on a local link in RA messages.

Syntax
ipv6 nd mtu number
Parameters
  • mtu number — Enter the MTU size in bytes (1280 to 65535).
Defaults
1500 bytes
Command Mode
INTERFACE
Usage Information
The no version of this command restores the default MTU value advertised in RA messages.
Example
OS10(config)# interface ethernet 1/2/3
                                       OS10(conf-if-eth1/2/3)# ipv6 nd mtu 2500
                                    
Supported Releases
10.4.0E(R1) or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\