OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

ipv6 nd other-config-flag

Sends RA messages that tell hosts to use stateful autoconfiguration to obtain nonaddress-related information.

Syntax
ipv6 nd other-config-flag
Parameters
None
Defaults
Not configured
Command Mode
INTERFACE
Usage Information
The no version of this command disables the other-config-flag option in RA messages.
Example
OS10(config)# interface ethernet 1/2/3
                                       OS10(conf-if-eth1/2/3)# ipv6 nd other-config-flag
                                    
Supported Releases
10.4.0E(R1) or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\