OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

ipv6 nd ra-lifetime

Sets the lifetime of the default router in RA messages.

Syntax
ipv6 nd ra-lifetime seconds
Parameters
  • ra-lifetime seconds — Enter a lifetime value in milliseconds (0 to 9000 milliseconds).
Defaults
3 times the max-ra-interval value
Command Mode
INTERFACE
Usage Information
The no version of this command restores the default lifetime value. 0 indicates that this router is not used as the default router.
Example
OS10(config)# interface ethernet 1/2/3
                                       OS10(conf-if-eth1/2/3)# ipv6 nd max-ra-interval 300
                                    
Supported Releases
10.4.0E(R1) or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\